The Pre-Treat Express is the fastest and easiest way to pre-treat garments to be printed on a DTG, significantly improving both print quality and production rates.
The Pre-Treat Express sprays the perfect amount of pre-treat solution onto the shirt every time. Eliminate the guesswork or learning curve of treating by hand and get perfectly pretreated shirts, ready to be printed, every time. Just load the shirt on the plexi-shirt board, press the start button, and in seconds you have a pre-treated shirt!
The Pre-Treat Express comes fully assembled, and is compact enough to easily move around in your shop. This one piece of equipment can dramatically increase production efficiency and reduce waste caused by printing on improperly pre-treated garments, and never again over-treating a garment.
The Pre-Treat Express requires a small air compressor (at least 0.3 HP) which is not included. Basic model is a table-top unit, legs are available for an additional cost. See brochure for additional options.
|
